JUAL 13.56MHz RFID/NFC Bracelet - 1KB

[Angels76]

13.56MHz RFID/NFC Bracelet - 1KB
Rp. 65.000
Beli

Lokasi : Jawa Timur (Bisa COD) Kondisi : New Posted on : 09-10-2016 14:08 Terjual : 0 barang telah terjual Dilihat : 23 kali Berat : 25 gram Last Sundul : 09 October 2016, 02:08:50 PM


Penjelasan Produk

DESCRIPTION

This is a blank 13.56MHz RFID/NFC silicone bracelet. The tag contains a small RFID chip and an antenna, and is passively powered by the reader/writer when placed a couple inches away.



These can be read by almost any 13.56MHz RFID/NFC reader but make sure it can handle ISO/IEC 14443 Type A cards as there are a few other encoding standards (like FeLica) They are tested and work great with both our PN532 NFC/RFID breakout board and Adafruit NFC/RFID Shield for Arduino!



These chips can be written to & store up to 1 KB of data in writable EEPROM divided into banks, and can handle over 100,000 re-writes. You can use our PN532 NFC/RFID breakout board or Adafruit NFC/RFID Shield for Arduino to read and write data to the EEPROM inside the tag. There is also a permanent 4-byte ID burned into the chip that you can use to identify one tag from another - the ID number cannot be changed.



These use a ISO/IEC 14443 Type A chipset, which used to be the 'classic' NFC chipset. In ~2014, the NFC forum decided not to support this chipset anymore, so newer phones do not support it. This only matters if you're trying to use this tag with a phone/tablet.



TECHNICAL DETAILS

RFID chip specification:



1 KiloByte (8 KiloBit) non-volatile EEPROM storage

Built in encryption engine with 48-bit key

4 Byte unique identifier burned into the chip

13.56 MHz frequency

Bracelet specification:



Fits wrists/ankles/hands up to 70mm (2.75") diameter 25.4mm diameter

Bracelet made of rugged waterproof silicone

0.9 grams / 0.03 oz

Works about 1" away from reader

Weight: 14.86g

• elektronik

.* .*